Use pfsense as router

I think the open source stuff is a great low cost option for SMB.The CPU plays a large part of any product, whether we think so or not.

The pfsense box choked at 20Mpbs constant traffic, latency was unbelievable. 1814 takes that and smiles back.This holds true with any of the firewall distros (IPCop, Smoothwall, etc.).A quick guide on how to setup Wi-Fi with pfSense to create an all-in-one router, firewall, security and Wi-Fi appliance.

pfSense and wireless - Overclock.net

If you want the Cisco on the edge, what do you want to have PFSense for on the inside.As a routing platform, the Cisco does much better than any home brewed firewall. No contest.

Tutorial on how to set up a multi VLAN network with VPN routing and segmentation.I see many people like pfsense lately it also had openvpn support, I was looking at a few high end routers the.The PFSense will have a LAN IP, but the WAN IP will be on the same subnet.In all seriousness, I believe that the comment was in regards to home-based systems, where one could assemble a very high end PC to handle firewall duties.

You should be running a pfSense firewall | InfoWorld

pfSense (or other dedicated router) questions | Page 2

Guides to Replacing and Upgrading Your Router with pfSense®

I have never built a router nor used PfSense, although I have a good idea of how it works.

Building the Ultimate VirtualBox Lab - Install pfSense

My cisco 2611xm with the 256mb ram upgrage beats the pants off the p3 733mhz with 4x intel nics pfsense box I hand in both reliability and latency. my latency was always higher with pfsense.Even though xphil3 can be a little harsh sometimes, I agree with him most of the time.

pfSense Tutorial BSDCan 2008

pfSense - Wikipedia

This is a very popular setup configuration as running your OpenVPN encryption on a.It is installed on a physical computer or a virtual machine to make a.An existing wireless router, such as a Linksys WRT54G, may be used with pfSense in the following way.Configure a professional firewall using pfSense. and D-link users with no firewall or router experience. Two good reasons to use pfSense.

Again, for most people, they would never care (or notice) a few small hiccups every now and then.Explains how to setup dual wan pfSense based router to load balance and failover internet connection.Dead thread, vito pasted it to me just now. but I really want to know why you think this.

pfSense router setup – NordVPN

How to setup Wi-Fi with pfSense - ServeTheHome

To meet your requirements for not using double nat, you will need to run PFsense in transparent mode (layer 2).

Setting Up Computer as Router/PFSense with Comcast

I use pfsense (and ipcop in the past) and have had far fewer issues, plus a much lower learning curve,.I got better performance out of a PIX 520 than I got out of that Smoothwall.

OpenVPN Step-by-Step Setup for pfsense [firewall/router

Might want to also consider untangle if your trying to do some sort of spam, internet, etc filtering.

Pfsense as a router within proxmox | Proxmox Support Forum

Seriously.compare the performance and traffic shaping of those models against even an old P3 and 256 meg rig running PFSense.

Get out and use some other products and maybe that will open your eyes a bit.Also, FWIW: I have used a P3 based firewall. pfSense had issues with the network cards, but under smoothwall it was a crapshoot.

Newbie to VPN - Cisco Router to pfSense IPSec problems

Want to use your TorGuard VPN service on a pfsense enabled firewall device.I am not too familiar with how good the inspect code is on PFsense but if you start using something more along the lines of an IPS you will be very happy with it.I went back to my cisco due to issues I had with pfsense involving gaming, and it was a cross platform issue on my ps3 and my pc.It has nothing to do with the fact that I work with this equipment daily, it has to do with the fact that Ive use both opensource firewalls and cisco routers AT home and tested ALL of them and generally the cisco routers comes out on top on all accounts.

I have a question on the PFSense firewall (probably can be universal, though).I guess my only other option would be double NAT, with the Cisco doing a private IP and the PFSense doing a different subnet and a private IP, too.

Rob Peck : Switching to pfSense

NAS/pfsense router using unraid possible? - Servers and

This is a tutorial on how to set up an OpenVPN connection to NordVPN from your pfSense router. pfSense version 2.2.3 1. Download the.